Subject: Re: General Maintenance Author: sanders : member since April, 2005 : 389 posts Posted on: 2011-09-13 18:49:18

00 00 610 Engine oil service (N62/N62TU)
Recycling:
Catch and dispose of used oil.
Observe country-specific waste-disposal regulations.
Note:
For purposes of clarity, this work step is shown without the
reinforcement plate.
Open oil drain plug (1) in oil sump.
Remove oil drain plug (2) on oil filter cap (3).
Release oil filter cover (3).
Installation:
Replace and lubricate sealing rings (1 and 2).
Replace oil filter element (3) and slide into oil filter cover.
Oil filter element (3) must snap audibly into place.
Installation:
Replace sealing ring.
Install oil drain plug (1) and tighten down.
Tightening torque 11 13 1AZ .
Insert and tighten down oil filter cover (3).
Tightening torque 11 42 2AZ .
Insert oil drain plug (2) on oil filter cap (3) and tighten down.
Tightening torque: 10 Nm.
RA Engine oil service (N62/N62TU) BMW AG - TIS 13.09.2011 18:16
Pour in engine oil.
Start engine and run at idle until oil indicator lamp goes out.
Switch off engine, wait approx. 5 minutes and then check engine oil
level.
Top up engine oil if necessary.
RA Engine oil service (N62/N62TU) BMW AG - TIS 13.09.2011 18:16

Sanders


After: With 21" Style 128's


Before: '02 745i, Titanium Silver and loving every minute



'97 540iA, Cosmos Black, Staggered Style 32's
Gone but not forgotten

• General Maintenance - catanzaro 2009-10-18 10:14:25 (1400 views)
  • Re: General Maintenance - rondo8 2011-08-27 15:35:17 (177 views)
    • Re: General Maintenance - sanders 2011-09-13 18:49:18 (124 views)